Product Description
SPRAY DEGREASER CYLINDER removes grease and tough grime from any surface. Non-corrosive to metals, has low toxicity (contains no carbon tetrachloride) and is not a fire hazard. Dries fast and clean without residue. Will not short motors, generators or electrical equipment.
SPRAY DEGREASER CYLINDER is a fast acting, quick drying, chlorinated hydrocarbon type solvent. Will not short motors or electrical equipment. High dielectric strength, nonexplosive, nonflammable, noncorrosive and dries clean. Pressurized can sprays solvent into hard to reach areas and instantly dissolves grease, grime, oils, waxes, gums, tars and is excellent for adhesive cleanup. Great for shops and on a job site.
Features and Benefits
- Meets USDA Standards
- No 1,1,1 Trichloroethane
- No Ozone Depleting Substances
- Dissolves Grease, Grime, Oil, Waxes, Gums, Tars, Etc.
Directions:
Do not use on plastics. Harmful to some paints. Pretest in a small area.
DEGREASER AND CLEANER: For use on refrigeration and air conditioning units and parts, engines of all types, large and small electrical motors, outboard motors, magnetos, generators, electrical equipment, and contacts, kitchen exhaust fans and vents, small power, and hand tools. Spray on and wipe off.
BRAKE PARTS CLEANER: Removes fluid and grease from linings and drums. Spray brake parts liberally and wipe clean with a cloth. Follow OSHA rules fro brake parts with asbestos. DO NOT use forced air on asbestos brakes. Clean up spilled solvent immediately.
SPOT REMOVER: Removes small grease and oil stains from most rugs, carpets, upholstery, and clothing. Spray soiled area then blots dry with an absorbent towel. It is important to pretest a small area before using a degreaser for this application.
Spray Tip Assembly Directions
When replacing your spray tip (or troubleshooting a leaking/clogged gun or one that will not stop spraying) … ensure that the spray tip is assembled in the order shown below.
Instructions:
- Place spray tip (No.3) into nut (No. 4). Ensure tip protrudes from nut.
- Place seat (No. 2) into nut (No. 4) with flat side facing (and sitting atop) spray tip.
- Screw assembled spray tip onto spray gun (No. 1).
- Tighten with wrench.
Important: Seat (No. 2) needs to be placed with flat side facing spray tip (protrusion facing spray gun). If the seat is positioned incorrectly, the spray gun may not work properly (leaking, clogging, constant spraying and other problems may arise).
DANGERS & PRECAUTIONS:
Read and understand the product’s label and Safety Data Sheet. It contains gas under pressure; May explode if heated. It causes skin and eye irritation. Suspected of causing cancer. Containers of this material may be hazardous when empty. Material is heavier than air. Material may concentrate in low lying areas. This material is toxic to aquatic life. Do NOT handle or use this product until all safety precautions have been read and understood. Keep out of the reach of children. Use only outdoors or in a well-ventilated area. Wear safety glasses and chemical resistant gloves. Keep away from heat, sparks, open flames, and hot surfaces. No smoking. Wash hands thoroughly after handling.
Equivalent Part Numbers: 6642, 6642-15CL, 664215CL, SDSSC
